Building a sliding lid box or a matchbox with the Slide Box Generator

Difficulty: easy. Time: 10 minutes to set up, about 45 minutes to cut and assemble. Best method: laser cut 3 mm plywood.

The Sliding lid box keeps its lid in rails, so it cannot lift off. The Matchbox style pushes an open tray in and out of a sleeve.

How well either one slides depends on the Slide clearance, so measure your sheet and test the fit before gluing.

Example of Slide Box Generator
On this page (4)
  1. 1. Pick the style
  2. 2. Set the inside size
  3. 3. Tune the slide
  4. Laser cutting

What you need

  • 3 mm plywood or acrylic. Measure it with calipers.
  • Wood glue, or acrylic cement for acrylic

1. Pick the style

Under Style, choose Sliding lid or Matchbox. Turn on Thumb notch for a finger hole in the sliding lid, or for notches in the matchbox sleeve and tray front.

Screenshot of the Slide Box Generator: 1. Pick the style

2. Set the inside size

Enter the Inside width, Inside depth and Inside height you need for the contents. For the sliding lid box, the height is measured below the lid.

Screenshot of the Slide Box Generator: 2. Set the inside size

3. Tune the slide

  • Set Material thickness to what you measured, not the number on the label.
  • Finger width sets how many fingers each joint gets.
  • Slide clearance is the gap around the lid in its rails, or between the tray and the sleeve. Raise it if the parts stick, and lower it if they wobble.
Screenshot of the Slide Box Generator: 3. Tune the slide

Choose your build method

Laser cutting

Cut and assemble

  1. Download the SVG and cut every panel.
  2. Assemble the box or the sleeve and check that the lid or tray slides before gluing.
  3. Glue the joints, keeping glue away from the rails.

Next steps and project ideas

  • Engrave the lid or the tray front.
  • Make a set of matchboxes in different sizes to organise a drawer.
  • Try the Inspirational Palette under the preview to compare wood and colour combinations.

Take the design into your software

Was this guide helpful?