Building an organiser box with compartments with the Divider Box Generator

Difficulty: medium. Time: 15 minutes to plan, about an hour to cut and assemble. Best method: laser cut 3 mm plywood or acrylic.

Plan the box from the inside out: set the inside size first, then split it into rows and compartments to fit what you want to store.

Every finger joint and divider slot is sized from the Material thickness you enter, so measure your sheet first.

Example of Divider Box Generator
On this page (4)
  1. 1. Set the inside size
  2. 2. Plan the compartments
  3. 3. Lid and material
  4. Laser cutting

What you need

  • 3 mm plywood or acrylic. Measure it with calipers.
  • Wood glue, or acrylic cement for acrylic

1. Set the inside size

Under Inside size, enter the Width, Depth and Height of the inside of the box.

Screenshot of the Divider Box Generator: 1. Set the inside size

2. Plan the compartments

  • Rows run from the back of the box to the front.
  • Each row has its own number of compartments. The note under it shows how wide and deep each compartment is.
  • Divider height can be lower than the walls, so small items are easier to pick out.
  • Lock dividers into the walls slots the dividers into the walls, and Finger notches cut a round notch in the top of each short divider.
Screenshot of the Divider Box Generator: 2. Plan the compartments

3. Lid and material

  • Turn off Slip-over lid for an open tray, or set its Lid height and Lid clearance.
  • Set Material thickness to what you measured, so the finger joints and divider slots fit snugly.
Screenshot of the Divider Box Generator: 3. Lid and material

Choose your build method

Laser cutting

Cut and assemble

  1. Download the SVG and cut every part.
  2. Build the outer box.
  3. Slot the long and short dividers together, then lower them into the box.
  4. Assemble the lid if you chose one, and glue once everything fits.

Next steps and project ideas

  • Size the compartments for screws, beads, tea bags or paint pots.
  • Cut it from clear or frosted acrylic so you can see what is inside.
  • Try the Inspirational Palette under the preview to compare wood and colour combinations.

Take the design into your software

Was this guide helpful?