Print and cut MyLaserTools designs in Silhouette Studio
Silhouette Studio opens SVG files from Designer Edition up. With the free Basic Edition, open the PNG instead and let Studio trace the cut line. Either way, Studio prints its own registration marks and the Cameo reads them to cut around the print.

On this page (5)
What you need
- A Silhouette Cameo or Portrait, a cutting mat and a home inkjet printer
- Printable sticker paper or cardstock
- The transparent PNG from the tool, and the SVG if you have Designer Edition
1. Set up the page
In Page Setup, choose your paper size and the cutting mat. Open Registration Marks and turn them on. Keep the design inside the area the marks leave free; the hatched corners are where the marks print.
2. Bring in the design and its cut line
With Designer Edition, open the SVG. The picture and its cut line come in together, at the size you set in MyLaserTools. If the picture is missing, place the PNG and line it up with the cut line. With Basic Edition, place the PNG, open the Trace panel and trace the outer edge. Check that small holes, like a keyring hole, were traced too, and measure the width before you print.
3. Print, then cut
Print the page at 100% with the registration marks. In the Send panel, check which lines are highlighted for cutting: the outline and any holes, nothing inside the picture. Put the print on the mat the same way round as on screen, let the Cameo read the marks, and cut.
Troubleshooting
- Studio will not open the SVG: Basic Edition does not open SVG. Open the PNG and trace it, or upgrade to Designer Edition.
- The marks are not found or the cut drifts: print at 100%, keep the design away from the marks and check all three printed fully. If it still drifts, run the Print and Cut calibration in Studio.
Manufacturer documentation
Next steps and project ideas
Next: make a first sticker with photo keychains, or cut vinyl city maps with maps on a Cricut or Silhouette.
Take the design into your software
Was this guide helpful?
More in Your software
Keep up with MyLaserTools.
Email me about new tools, product updates, tutorials, and occasional MyLaserTools offers. Unsubscribe at any time.
© 2026 MyLaserTools.com. All rights reserved.




