Building a finger-jointed box with a slip-over lid with the Slip Lid Box Generator

Difficulty: easy. Time: 10 minutes to set up, about 45 minutes to cut and assemble. Best method: laser cut 3 mm plywood.

The lid is a shallow box of its own that slips over the top of the walls, so it needs no hinges or rails.

If the lid binds, raise the Lid clearance. If it rattles, lower it.

Example of Slip Lid Box Generator
On this page (4)
  1. 1. Set the inside size
  2. 2. Shape the lid
  3. 3. Match your material
  4. Laser cutting

What you need

  • 3 mm plywood or acrylic. Measure it with calipers.
  • Wood glue, or acrylic cement for acrylic

1. Set the inside size

Under Inside size, enter the Width, Depth and Height you need to fit your contents.

Screenshot of the Slip Lid Box Generator: 1. Set the inside size

2. Shape the lid

  • Lid height sets how far the lid reaches down over the walls, including the top.
  • Lid clearance is the gap on each side between the walls and the lid. Raise it if the lid binds.
  • Under Lid grip, choose None, Handle or Hole. The handle tabs into two slots in the lid.
Screenshot of the Slip Lid Box Generator: 2. Shape the lid

3. Match your material

Set Material thickness to what you measured, not the number on the label, so the finger joints press together snugly. Finger width sets how many fingers each joint gets.

Screenshot of the Slip Lid Box Generator: 3. Match your material

Choose your build method

Laser cutting

Cut and assemble

  1. Download the SVG and cut every panel.
  2. Press the walls and the base of the box together.
  3. Assemble the lid the same way, and push the handle into its slots if you chose one.
  4. Check that the lid slips on before gluing.

Next steps and project ideas

  • Engrave a name or a pattern on the lid.
  • Make a gift box sized to the present and cut the lid from a contrasting material.
  • Try the Inspirational Palette under the preview to compare wood and colour combinations.

Take the design into your software

Was this guide helpful?