Weave pintograph

Weave: a pintograph, a drawing machine with two turning discs. The crank turns a small drive gear that meshes with both discs; the right one has a few more…

Settings

Units

Drawing

Right teeth
Teeth on the right disc, against 60 on the left: fewer teeth make a finer weave and more crank turns
Left pin
Hole the left arm's pin goes in, as its distance from the disc centre
Right pin
Hole the right arm's pin goes in
Arm length
Arm length, pin to pencil: longer arms draw higher up the paper and flatter

Fit

Backlash
Total play between two meshing gears, at the pitch circle
Bearing clearance
Added to the 6 mm holes that turn on brass bushes

Assembly

Crank angle
goes past one turn

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Weave pintograph

About this design

Laser cut & 3D print

Weave: a pintograph, a drawing machine with two turning discs. The crank turns a small drive gear that meshes with both discs; the right one has a few more teeth than the left, so it slowly falls behind. An arm on a pin in each disc carries the pencil where the two arms cross, and it draws loop after loop, each a little different, weaving a cushion of lines.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs