Library Bookcase

A miniature for book nooks and dioramas. Library bookcase: a miniature bookcase with its rolling-style ladder, for dioramas, dollhouses and book nooks. The…

Settings

Switch to Batch to make the same design for a list of names.

Units

Bookcase

Case width
Width, real cm
cm
Case depth
Depth, real cm
cm
Case height
Height, real cm
cm
Shelves
Shelves
Ladder
The ladder on its rail
Initial
The initial on the bookmark
Base
A base plate to stand it on
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Library Bookcase

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Library bookcase: a miniature bookcase with its rolling-style ladder, for dioramas, dollhouses and book nooks. The bookcase is a tab-and-slot box of sides, a back, shelves and a top, with rows of books standing in slots on every shelf and, with the ladder, a brass rail tabbed across the front. The ladder's two rails lean back to that rail and hook over it through notches in their tops; its treads tab into the rails and its feet stand in the base. One book on the top shelf has a ribbon bookmark with an initial on it. Assembly: build the bookcase and stan

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs