Vampire Coffin

A miniature for book nooks and dioramas. Coffin: a miniature vampire's coffin for dioramas, Halloween and book nooks. A true coffin shape from every side: a…

Settings

Units

Coffin

Coffin length
Length, real cm
cm
Coffin height
Height, real cm
cm
Open
The lid slid open
Plinth
A stone plinth under it
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Vampire Coffin

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Coffin: a miniature vampire's coffin for dioramas, Halloween and book nooks. A true coffin shape from every side: a stack of coffin-shaped rings on a solid floor, aligned by two keys that stand in the floor's slots and slide through notches in every ring; no corner joints to show. The lid is two layers, closed or slid half open on the velvet and the rose inside. It can stand on a stone plinth. Assembly: stand the keys in the floor, thread the rings down over them, glue each, lay the lid on; set it all on the plinth.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs