Spell-Book Stand

A miniature for book nooks and dioramas. Spell-book stand: a miniature lectern for dioramas, libraries and book nooks. Two shaped sides hold a sloping book…

Settings

Units

Stand

Stand width
Width, real cm
cm
Stand depth
Depth, real cm
cm
Stand height
Height at the back, real cm
cm
Books
Books on the shelf
Base
A base plate to stand it on
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Spell-Book Stand

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Spell-book stand: a miniature lectern for dioramas, libraries and book nooks. Two shaped sides hold a sloping book rest and a low shelf, both tabbed into slots in the sides; the rest sits a lip below the sides' top edges, which keep the book from sliding off. An open book with a ribbon is engraved on the rest, and a row of books can stand on the shelf. Assembly: push the shelf and the rest into one side, add the other side, stand the books in their slots.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs