Roll-Top Shutter Box

Shutter box: a box with a roll-top lid. The lid is a row of slats whose narrow ends ride in a channel inside each side, so it slides back round the curved…

Settings

Units

Box

Width
Outside width
Depth
Outside depth
Height
Outside height
Corner
Radius of the curved back corner
Slat width
Width of each slat
Slat gap
Gap between slats

Assembled view

Open
How far the shutter is open, 0 to 1

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Play
Play for the slats in the channel, each side
Clearance

3D Preview

Building your model
Inspirational Palette

Code

Photos

Roll-Top Shutter Box

About this design

Laser cut & 3D print

Shutter box: a box with a roll-top lid. The lid is a row of slats whose narrow ends ride in a channel inside each side, so it slides back round the curved corner and down behind the back wall. The channel is the gap left between a guide plate and a rim, glued to each side wall. Assembly: glue a guide and a rim to each side wall, fit the front, back and bottom into one side and add the other. Glue the slats face down on a strip of canvas, leaving their ends free, and slide them in from the front.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs