Pirate Chest

Pirate chest: a finger-jointed chest with a barrel lid of narrow staves laid over two arched ends, hand holds in the ends and a lock plate with an engraved…

Settings

Units

Chest

Width
Outside width
Depth
Outside depth
Body height
Height of the chest below the lid
Arch
Height of the lid's arch
Stave width
Width of each stave

Assembled view

Lid angle
Lid opening angle

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Pirate Chest

About this design

Laser cut & 3D print

Pirate chest: a finger-jointed chest with a barrel lid of narrow staves laid over two arched ends, hand holds in the ends and a lock plate with an engraved keyhole. Each lid end is two layers glued together, so every stave has a broad edge to glue to, and the lid hangs on two leather straps glued across the back, the way old sea chests were hinged. Assembly: glue the chest, and glue each pair of lid ends together. Stand the lid ends on the chest's ends and glue the staves on one at a time from the back, keeping the gaps even. Glue two leather straps, 20 mm wide, from the back wall up over the

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs