Pulley Wheel

A grooved sheave for rope, cord and wire, with a seat for a 608, 625 or 623 skate bearing or a plain bore for a bolt. For clothesline pulleys, plant hoists…

Settings

Units

Rope

Rope
Rope or cord diameter in mm
mm
Diameter
Groove bottom diameter in mm
mm

Hub

Hub
What the wheel turns on
Pin
Plain bore diameter in mm
mm
Fit
Extra room on the bearing seat in mm
mm
Spokes
Lighten the wheel with holes

Print

Count
Number of wheels

3D Preview

Building your model
Inspirational Palette

Code

Photos

Pulley Wheel

About this design

Written in OpenSCAD · 3D print

A grooved sheave for rope, cord and wire, with a seat for a 608, 625 or 623 skate bearing or a plain bore for a bolt. For clothesline pulleys, plant hoists, bike ceiling lifts and kinetic builds.

The 45 degree V groove keeps the rope centred. Prints flat with no supports.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download STL for any slicer, or 3MF to keep the coloured parts apart.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

STL for any slicer, and 3MF with each coloured part kept as its own object.

The size follows the settings on this page, and the size box under the preview shows the result.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Hardware Designs

Similar designs