Tie-Down Ring

A folding D-ring anchor for truck beds, trailers, crates, garden netting and gym straps. The ring comes off the bed already trapped under its strap, and folds…

Settings

Units

Ring

Ring width
Inside width of the ring in mm
mm
Bar
Thickness of the ring bar in mm
mm
Clearance
Gap between the ring and the strap in mm
mm

Mounting

Screw
Screw hole diameter in mm
mm
Strap
Strap width along the ring bar in mm
mm

Print

Count
Number of anchors

3D Preview

Building your model
Inspirational Palette

Code

Photos

Tie-Down Ring

About this design

Written in OpenSCAD · 3D print

A folding D-ring anchor for truck beds, trailers, crates, garden netting and gym straps. The ring comes off the bed already trapped under its strap, and folds flat when you are not using it.

Prints flat in place with no supports. Screw down both pads.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download STL for any slicer, or 3MF to keep the coloured parts apart.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

STL for any slicer, and 3MF with each coloured part kept as its own object.

The size follows the settings on this page, and the size box under the preview shows the result.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Hardware Designs

Similar designs