
Crank Handle
A hand crank with a square, hex, round or D bore and a grip that spins on its pin. For awning winders, pasta rollers, window cranks, winches and anything with…
Settings
Bore
Crank
3D Preview
Photos

About this design
Written in OpenSCAD · 3D print
A hand crank with a square, hex, round or D bore and a grip that spins on its pin. For awning winders, pasta rollers, window cranks, winches and anything with an adjusting screw.
The arm prints flat and the grip prints upright, then snaps onto the pin. A pointed set screw hole holds it on the shaft.
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download STL for any slicer, or 3MF to keep the coloured parts apart.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
STL for any slicer, and 3MF with each coloured part kept as its own object.
The size follows the settings on this page, and the size box under the preview shows the result.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









