Wellspring saqiya water wheel

Wellspring: a saqiya, the animal-driven water wheel al-Jazari drew in the 13th century. Turn the ox round its walk and the draw-bar turns a peg wheel above…

Settings

Units

Mechanism

Crown pegs
Pegs on the horizontal crown wheel; the lantern has 8 staves, so this sets the ratio
Pots
Pots around the water wheel

Fit

Bush fit
Added to the 6 mm holes the brass bushes are glued into
Dowel fit
Added to the 6 mm holes the dowel pegs and staves are glued into
Tab fit
Added to the slots the tabs fit into

Export

Output
All parts, or one group at a time

Assembly

Draw bar angle
Draw-bar angle in the assembled view, counterclockwise from the axle

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Wellspring saqiya water wheel

About this design

Laser cut & 3D print

Wellspring: a saqiya, the animal-driven water wheel al-Jazari drew in the 13th century. Turn the ox round its walk and the draw-bar turns a peg wheel above the gear pit; its dowel pegs drive a lantern pinion at right angles, and the wheel on the same axle lifts a ring of pots out of the well and tips them into the trough at the top.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs