Pad Folio

Pad folio: a wooden cover for a notepad, a block of loose sheets or a tablet. The front and back covers are one piece joined by a living hinge spine, worked…

Settings

Switch to Batch to make the same design for a list of names.

Units

Folio

Pad size
Size of the pad it holds, width by height
Custom width
Custom pad width
Custom height
Custom pad height
Pad thickness
Thickness of the pad, backing board included
Organiser
Card and note pockets inside the front cover
Elastic
Holes for an elastic band to keep it shut
Title
Title on the front
Subtitle
Line under it; leave empty for none

Material

Material thickness
Sheet thickness; the spine bends best in 3 mm plywood or thinner
mm
Kerf
Width of material the laser burns away.
mm
Spacing
Distance between the hinge cuts: closer bends easier

3D Preview

Building your model
Inspirational Palette

Code

Photos

Pad Folio

About this design

Laser cut & 3D print

Pad folio: a wooden cover for a notepad, a block of loose sheets or a tablet. The front and back covers are one piece joined by a living hinge spine, worked out to close round whatever it holds. On the back cover four corner posts, stacked to the pad's thickness, carry caps that reach over its corners and hold it in. Inside the front cover a card pocket and a pocket for notes and receipts, built like a wallet: a spacer with the pockets cut from it under a face with a window at the top of each. Your title is engraved on the outside, and an elastic band through two holes in the back cover keeps

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs