
Flag
A miniature for book nooks and dioramas. Pride flag on its stand: a desk flag for your desk or shelf, or a miniature for a book nook. The pole and the flag…
Settings
Flag
Material
3D Preview
Photos

About this design
Laser cut & 3D print
A miniature for book nooks and dioramas. Pride flag on its stand: a desk flag for your desk or shelf, or a miniature for a book nook. The pole and the flag are cut in one and stand in a base that reaches under the flag. The engraved finish uses scored stripes and selective hatching. For colour finishes, glue the Progress flag's chevrons or the Intersex flag's ring onto the flag.
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









