Layered Camera

Camera model: a retro rangefinder camera built up in layers, front to back, with a stacked lens, a knurled focus ring and an acrylic glass. The walnut middle…

Settings

Switch to Batch to make the same design for a list of names.

Units

Camera

Width
Width of the body
Brand
Name on the front
Lens layers
Lens length, in layers
Band
Band layers between the front and the back

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Window thickness
Acrylic for the lens glass

3D Preview

Building your model
Inspirational Palette

Code

Photos

Layered Camera

About this design

Laser cut & 3D print

Camera model: a retro rangefinder camera built up in layers, front to back, with a stacked lens, a knurled focus ring and an acrylic glass. The walnut middle layers make the leather band, and they are hollow, so with the back plate lifted off it is a little keepsake box. Engrave your own name on the front. Assembly: glue the front plate, the band frames and the lens rings in order, lining up the edges. The back plate is a push fit, held by the two corner pins.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs