Six-Pack Carrier

Six-pack carrier: two rings hold the bottles apart so they never clink, a tall spine with a hand hole carries the load, and the end plates are screwed on with…

Settings

Units

Bottles

Bottle
Bottle diameter
Bottle height
Bottle height
Per row
Bottles in a row; there are two rows
Ease
Room round each bottle

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Clearance
Screw
Screw size: M3 or M4

3D Preview

Building your model
Inspirational Palette

Code

Photos

Six-Pack Carrier

About this design

Laser cut & 3D print

Six-pack carrier: two rings hold the bottles apart so they never clink, a tall spine with a hand hole carries the load, and the end plates are screwed on with captive nuts, so it comes apart flat. The spine is screwed to both end plates and the end plates to the base, so the weight of the bottles hangs on screws, never on a push fit. Set the bottle size and how many in a row; the rings and handle follow. Assembly: slide both rings up the spine from below and plug the spine's tabs into the base. Fit the end plates over the tabs of the base, the rings and the spine, then screw them on: a nut dro

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs