
Motorcycle on a Lift
A miniature for book nooks and dioramas. Motorcycle on a lift: a vintage café racer for dioramas, garages and book nooks, standing on a scissor lift table…
Settings
Motorcycle
Material
3D Preview
Photos

About this design
Laser cut & 3D print
A miniature for book nooks and dioramas. Motorcycle on a lift: a vintage café racer for dioramas, garages and book nooks, standing on a scissor lift table. The bike is a layered profile: the body (front wheel, fork, frame, engine, seat, exhaust, and a paddock stand under the swingarm, because its rear wheel is off for repair) is one piece standing in two slots in the lift's top; the tank and the engine covers are glued on both faces for depth, and the handlebar crosses the riser in a halving joint. The rear wheel stands in its own slot beside it. The lift is a top plate on two one-piece scisso
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









