Tile Keychain

Tile keychain: a word spelled in letter tiles, all on one keychain. Each tile has its letter engraved large and its place in the alphabet small in the corner…

Settings

Switch to Batch to make the same design for a list of names.

Units

Keychain

Word
The word
Size
Size of a tile
Round
Corner rounding of the tiles
Tab
Where the ring tab goes
Backed
Separate tiles on a walnut back; without it, one piece

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Tile Keychain

About this design

Laser cut & 3D print

Tile keychain: a word spelled in letter tiles, all on one keychain. Each tile has its letter engraved large and its place in the alphabet small in the corner. The tiles sit side by side on a walnut back with a thin line of walnut showing between them, and the back carries the ring tab, so the word stays together and strong. Without the back it cuts as one piece with each tile scored round. Assembly: glue the tiles onto the back in order, lining them up with the scored marks, and thread a split ring through the tab.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs