Bloom expanding flower

Bloom: a mechanical flower that opens. Turn the drive ring in the middle and six couplers push six sculpted petals straight out along their radial guides, all…

Settings

Units

Flower

Petals
Number of petals
Leaf length
Petal length, from the inner pin to the tip
Leaf width
Petal width at its widest
Closing angle
Ring angle when the flower is closed; more gives more travel

Fit

Guide clearance
Added to the 6 mm guide slots and arc slots the sleeves slide in
Bearing clearance
Added to the 6 mm holes that turn on sleeves

Assembly

Ring angle
the closing angle (closed)

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Bloom expanding flower

About this design

Laser cut & 3D print

Bloom: a mechanical flower that opens. Turn the drive ring in the middle and six couplers push six sculpted petals straight out along their radial guides, all together, so the flower grows from 34 to 42 cm across; turn it back and the petals close again.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs