Cascade binary marble adder

Cascade: a marble computer that adds in binary. A column of rockers on a leaning board holds a number, one bit each: 1, 2, 4, 8 and 16 from the top. A marble…

Settings

Units

Counter

Bits
Number of bits; the board gets taller with each one
Marble
What the channels are sized for
Lean
How far the board leans back from upright, in degrees

Fit

Bush bore
Hole the brass bush of each rocker turns in, in the board

Assembly

Value
The number the rockers hold in the assembled view, 0 to 2^bits - 1

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Cascade binary marble adder

About this design

Laser cut & 3D print

Cascade: a marble computer that adds in binary. A column of rockers on a leaning board holds a number, one bit each: 1, 2, 4, 8 and 16 from the top. A marble that meets a 0 sets it to 1 and drops into the return channel; one that meets a 1 sets it back to 0 and rolls on to the next bit, the carry. Drop a marble into the slot marked 4 to add 4; lift the bar behind to reset.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs