Articulated cable chain

Cable chain: alternating wide and narrow U-links pivot on bought side bolts. Each link has two cheeks and one tabbed floor bridge. The channel stays open…

Settings

Units

Chain

Links
Channel width
Link height
Pitch
Pin diameter

Assembled view

Joint angle
Angle between successive links; this does not add a physical stop.

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Clearance
Pivot clearance
Axial gap

3D Preview

Building your model
Inspirational Palette

Code

Photos

Articulated cable chain

About this design

Laser cut & 3D print

Cable chain: alternating wide and narrow U-links pivot on bought side bolts. Each link has two cheeks and one tabbed floor bridge. The channel stays open. Assembly: glue each U-link square, then connect adjacent cheeks with short bolts, washers and locknuts. Keep the pivots loose enough to turn freely. This free-pivot prototype has no mechanical bend stops or machine rating.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs