
Horn Phone Stand
Horn phone stand: a solid block of layers that holds a phone at a lean and carries the sound of its speaker forward through a horn inside the block, flaring…
Settings
Phone
Material
3D Preview
Photos

About this design
Laser cut & 3D print
Horn phone stand: a solid block of layers that holds a phone at a lean and carries the sound of its speaker forward through a horn inside the block, flaring out to the front. The slot leans because each layer's cut steps back a little from the one below; the horn is cut through the layers under the slot. The front steps down so the screen stays clear. Assembly: glue the layers in order, base first, lining up the backs.
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









