Medal Hanger

Medal hanger: your word cut out large above rows of long hooks, for race medals with wide ribbons. Set how long the hooks are, how many rows each post carries…

Settings

Switch to Batch to make the same design for a list of names.

Units

Hanger

Word
The word on top
Motto
Words engraved along the bar
Width
Width of the bar; it grows if the hooks need more room

Hooks

Posts
Posts hanging under the bar, each carrying a column of hooks
Rows
Hooks stacked on each post
Hook length
Length of a hook: longer than your widest ribbon, or a few ribbons side by side
Point
Which way the hooks point
Frame
Join the posts in a frame round the hooks

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Medal Hanger

About this design

Laser cut & 3D print

Medal hanger: your word cut out large above rows of long hooks, for race medals with wide ribbons. Set how long the hooks are, how many rows each post carries and which way they point: right, left, both ways or in facing pairs. A frame round the hooks makes it one stiff piece. Spacers behind hold it off the wall, so a ribbon loops round a hook and hangs free. Assembly: glue a pair of spacers behind each screw hole and screw it to the wall through them. Choose a word whose letters all touch the line: dotted letters need a word of their own.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs