
Earring Tower
Earring tower: two pierced panels slotted across each other make four faces of earring holes, on a turntable so every face comes round to the front. Pairs of…
Settings
Tower
Assembled view
Material
3D Preview
Photos

About this design
Laser cut & 3D print
Earring tower: two pierced panels slotted across each other make four faces of earring holes, on a turntable so every face comes round to the front. Pairs of small holes take studs, larger ones take hooks, and the panels taper like a tree. It turns on a dowel through the base. Assembly: cross the panels at their middle slots, push their tabs into the turning base and glue. Glue the dowel into the bottom disc, add a washer and drop the base over it. The assembled view can turn it.
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









