
Wooden Eyeglasses Frame
Eyeglasses frame: a wooden front with acrylic lenses and two arms, sized from your own measurements: the lens width, lens height, bridge and arm length…
Settings
Frame
Assembled view
Material
3D Preview
Photos

About this design
Laser cut & 3D print
Eyeglasses frame: a wooden front with acrylic lenses and two arms, sized from your own measurements: the lens width, lens height, bridge and arm length printed on the inside of any pair of glasses you own. Choose round, soft square or upswept lenses. The arms fold in on real hinges: each is glued onto a tongue that turns on a pin between two lugs tabbed through the front. Assembly: glue the lugs into the slots in the front, two at each end, and press the lenses in from the back. Glue each arm's tabs into its tongue, slide the tongue between its lugs and push the pin down through, a snug fit in
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









