Relief Globe

Relief globe: a desk globe built up in layers, like a contour model. Each layer is a ring one sheet thick, its edge on the sphere over the oceans and standing…

Settings

Units

Globe

Diameter
Diameter of the oceans
Ring
Width of the rings
Relief
How far the land stands out
Tilt
Tilt of the axis

Assembled view

Spin
Turn of the globe, the longitude facing front

Material

Material thickness
Sheet thickness, also the rod's diameter
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Relief Globe

About this design

Laser cut & 3D print

Relief globe: a desk globe built up in layers, like a contour model. Each layer is a ring one sheet thick, its edge on the sphere over the oceans and standing out over the land, so the continents show in relief from every side as the globe turns. Two crossed plates inside key the rings in line, and solid discs close the poles. Short rods at the poles turn in channels inside a three-layer meridian arc, tilted like the Earth's axis, on a pedestal and a round base. Assembly: slot the two cross plates together. Slide the equator ring over them, its notches on their edges, then the others in order

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs