Iris Box

Iris box: a round box whose lid opens like a camera shutter. Eight curved blades meet in the middle; turn the ring on top and pins under it swing every blade…

Settings

Units

Box

Diameter
Outside diameter
Height
Height of the box under the lid
Staves
Wall staves around the box

Assembled view

Open
How far the iris is open, 0 to 1

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Pin
Pin diameter for the pivots and the drive
Clearance

3D Preview

Building your model
Inspirational Palette

Code

Photos

Iris Box

About this design

Laser cut & 3D print

Iris box: a round box whose lid opens like a camera shutter. Eight curved blades meet in the middle; turn the ring on top and pins under it swing every blade out on its own pivot, opening a round hole to reach in. The blades lie flat side by side and never overlap, so they can be cut from a flat sheet: walnut here, against the plywood box. Assembly: plug the staves into the base and the deck and glue them. Glue a pivot pin into each hole in the deck, drop the blades on, and glue the guard ring round them. Glue a drive pin into each hole in the drive ring, set it on with the pins in the blade s

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs