Bent pen tray

Pen tray: a desk tray whose round-bottomed trough is one strip of plywood bent by a living hinge, between two end plates. The strip's tabs go through slots in…

Settings

Switch to Batch to make the same design for a list of names.

Units

Tray

Length
Length, end to end inside
Width
Width of the trough inside
Depth
Depth of the trough
Label
Text on the ends; leave empty for none

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Bent pen tray

About this design

Laser cut & 3D print

Pen tray: a desk tray whose round-bottomed trough is one strip of plywood bent by a living hinge, between two end plates. The strip's tabs go through slots in the ends, which the ends cut for themselves from where the strip passes through them. Made with flex_strip() from kerf/hinge.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs