Knuckle Hinge Box

Knuckle hinge box: a finger-jointed box with its hinge cut from the same sheet. Knuckle plates tabbed into the back wall alternate with knuckles tabbed under…

Settings

Units

Box

Width
Outside width
Depth
Outside depth, without the hinge
Height
Height of the walls
Rod
Rod diameter: a nail, a piece of wire or a dowel
Knuckles
Knuckles in each of the two hinges, wall and lid together

Assembled view

Lid angle
Lid opening angle

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Clearance

3D Preview

Building your model
Inspirational Palette

Code

Photos

Knuckle Hinge Box

About this design

Laser cut & 3D print

Knuckle hinge box: a finger-jointed box with its hinge cut from the same sheet. Knuckle plates tabbed into the back wall alternate with knuckles tabbed under the lid, and one rod runs through them all. The lid stays outside a circle round the rod, so it turns clear of the back wall, and an inset plate under it keeps it square when shut. Assembly: glue the box, the wall knuckles and the lid knuckles. Thread the rod through, a snug fit in the wall knuckles and free in the lid's.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs