Stage Riser

A miniature for book nooks and dioramas. Stage riser: a miniature club stage for dioramas, dollhouses and book nooks. A deck on a box of a pleated skirt, a…

Settings

Units

Stage

Stage width
Width, real cm
cm
Stage depth
Depth, real cm
cm
Stage height
Height, real cm
cm
Gear
The gear on the stage
Base
A base plate to stand it on
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Stage Riser

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Stage riser: a miniature club stage for dioramas, dollhouses and book nooks. A deck on a box of a pleated skirt, a back and two sides, with ribs standing under the deck between them; everything tabs together and the deck locks it square. The deck is engraved with boards, the spotlight's pool and a setlist taped down, and it takes the band's gear in slots: an amp cabinet with its head, a drum kit, a mic stand, a guitar on its stand and a monitor wedge. Assembly: push the skirt and the back into the two sides, stand the ribs in the base, press the deck on

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs