Cat Tree

A miniature for book nooks and dioramas. Cat tree: a miniature cat tree with its cats, for dioramas, dollhouses and every cat person's shelf. Two cross-lapped…

Settings

Units

Cat tree

Tree width
Width, real cm
cm
Tree depth
Depth, real cm
cm
Tree height
Height, real cm
cm
Cats
Cats on it
Base
A carpeted base to stand it on
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Cat Tree

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Cat tree: a miniature cat tree with its cats, for dioramas, dollhouses and every cat person's shelf. Two cross-lapped posts wrapped in sisal: the tall one carries a platform that slides down over its narrow top and rests on the step where the post widens, and a perch on its top; the short one a carpeted den with a round doorway (and eyes in the dark inside). Cats stand in slots on the platform, the perch and the den. Assembly: slide each pair of posts together, stand them in the base, drop the platform onto its step, press the perch on, build the den on

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs