Laser Cutter

A miniature for book nooks and dioramas. Laser cutter: a miniature CO2 laser with its lid up, for dioramas, book nooks and a laser owner's shelf, and a diode…

Settings

Switch to Batch to make the same design for a list of names.

Units

Laser

Laser width
Width, real cm
cm
Laser depth
Depth, real cm
cm
Laser height
Height, real cm
cm
Shop name
The shop's name on the front
Diode
The diode laser beside it
Base
A base plate
Scale to
Scale, 1 : this (6 big desk model, 12 dollhouse, 20 book nook)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Laser Cutter

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Laser cutter: a miniature CO2 laser with its lid up, for dioramas, book nooks and a laser owner's shelf, and a diode laser on its open frame beside it. The CO2 laser's two sides take the front, the back and the honeycomb bed in slots; a sheet of birch lies on the bed half cut, the pieces of a tiny book nook in it; the lid is raised, its back edge tabbed into the back panel through a slot cut at its angle. The diode laser's rails stand in the base with the beam between their posts, the head on the beam over a coaster it is burning. Assembly: slide the be

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs