Stitching Pony

A miniature for book nooks and dioramas. Stitching pony: a miniature leatherworker's stitching pony for dioramas, book nooks and a leatherworker's shelf, a…

Settings

Switch to Batch to make the same design for a list of names.

Units

Pony

Initials
The initials on the maker's stamp
Tag
The tag on the bag
Length
Seat length, real cm
cm
Base
A base plate
Scale to
Scale, 1 : this (6 big desk model, 12 dollhouse, 20 book nook)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Stitching Pony

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Stitching pony: a miniature leatherworker's stitching pony for dioramas, book nooks and a leatherworker's shelf, a satchel clamped in its jaws with the maker's stamp (your initials) and a tag tied to its handle. The bench: two end frames and a stretcher under the seat. The crossbar stands in the seat at the front; the two jaws are lowered over it, their slots from below and its from above; the bag stands between the jaws on the crossbar. Assembly: slide the stretcher into the end frames and set the seat on them; stand the crossbar in the seat, lower the

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs