Bed with Nightstands

A miniature for book nooks and dioramas. Bed: a miniature bed for dioramas, dollhouses and book nooks. A headboard (tufted) and a footboard stand on their own…

Settings

Units

Bed

Size
Size
Bed length
Length, real cm
cm
Petals
A heart of rose petals on the duvet
Nightstands
Nightstands either side
Base
A base plate
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Bed with Nightstands

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Bed: a miniature bed for dioramas, dollhouses and book nooks. A headboard (tufted) and a footboard stand on their own feet; two side rails tab into slots in them and a slatted deck tabs into slots near the rails' tops, so the frame locks square. The mattress (its lower layer between the rails, the upper over them), the duvet and two pillows are glued layers; a heart of rose petals can lie on the duvet. Nightstands with drawers stand either side if you like. Assembly: push the rails' end tabs into the headboard and the footboard, drop the deck into the r

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs