
Split Monogram
Split monogram: a big initial with a band across its middle that carries a name, for a wedding table, a nursery wall or a door. The letters of the name are…
Settings
Switch to Batch to make the same design for a list of names.
Monogram
Material
3D Preview
Photos

About this design
Laser cut & 3D print
Split monogram: a big initial with a band across its middle that carries a name, for a wedding table, a nursery wall or a door. The letters of the name are sized to touch both rails of the band, and posts join the rails at the ends, so the whole monogram is one piece. It stands in a slotted plinth, or hangs from two holes. Assembly: glue the monogram's foot into the plinth.
Personal useCommercial use
How to make it
- 1Change the settings. The preview updates after each change.
- 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
- 3Like the design and add a photo of what you made below.
Questions
Yes. It is free to download and use under its licence.
Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.
An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.
The size follows the settings on this page, and the size box under the preview shows the result.
Set the material thickness to the sheet you cut. The slots and tabs follow it.
Yes. The licence covers personal and commercial use of the pieces you make.
Made by the community
Cut this one? Share a photo and a note about how it went and get 10 sparks right away.









