Tire Stack

A miniature for book nooks and dioramas. Tire stack: a miniature pile of tires for dioramas, garages and book nooks. Each tire is a few rings, its top and…

Settings

Units

Tires

Tire diameter
Tire diameter, real cm
cm
Tread
Tread width, real cm
cm
Tires
Number of tires
Base
A round base plate
Scale to
Scale, 1 : this (12 dollhouse, 20 book nook, 24 small)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Material

Material thickness
Sheet thickness in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Tire Stack

About this design

Laser cut & 3D print

A miniature for book nooks and dioramas. Tire stack: a miniature pile of tires for dioramas, garages and book nooks. Each tire is a few rings, its top and bottom ones a little smaller so the tires read apart; they stack on a cross-lapped core cut exactly as wide as their holes, which centres them, and the top one is a spare on its rim, which hides the core. Assembly: slide the two core plates together, set them in the base, thread the rings on, glue the rim on top.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs