Lambda Chebyshev walker

Lambda: a four-legged walker on Chebyshev's lambda linkage. One square shaft turns four eccentrics a quarter turn apart; each drives a lambda whose far end…

Settings

Units

Walker

Sole length
Length of each sole; longer soles stand steadier
Frame gap
Space between the two side frames, inside

Fit

Pivot clearance
Added to the 6 mm holes the brass bushes turn in
Shaft fit
Added to the 6 mm square holes for the shaft
Turn clearance
Total play of the journals in the frames and the couplers on their eccentrics
Slot fit
Added to the tab slots in the frames

Assembly

Crank angle
Shaft angle in the assembled view; only moves the parts

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Lambda Chebyshev walker

About this design

Laser cut & 3D print

Lambda: a four-legged walker on Chebyshev's lambda linkage. One square shaft turns four eccentrics a quarter turn apart; each drives a lambda whose far end follows an approximately level path before lifting and swinging back. The legs hang from those ends on flat soles. Turn the handle anticlockwise, seen from the handle side, to follow the walking motion.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs