Night Shift Garage Book Nook

Garage book nook: "Night Shift". Twenty to four in the morning. A vintage motorcycle stands on the lift table, half repaired: its rear wheel is off and stands…

Settings

Switch to Batch to make the same design for a list of names.

Units

Garage

Garage name
Name on the sign
Calendar note
The note on the calendar
Clock hours
The time on the wall clock (hours)
Clock minutes
The time on the wall clock (minutes)
Finish
How the details are cut: engraved, shaded in three engrave depths, or left plain

Size

Width
Outside width in millimetres
mm
Depth
Outside depth in millimetres
mm
Height
Outside height in millimetres
mm
Scale to
Furniture scale, 1 : this

Material

Material thickness
Sheet thickness in millimetres
mm
Fine
Thickness of the thin detail sheet in millimetres
mm
Kerf
Laser kerf in millimetres
mm
Clearance
Extra gap in the joints, in millimetres
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Night Shift Garage Book Nook

About this design

Laser cut & 3D print

Garage book nook: "Night Shift". Twenty to four in the morning. A vintage motorcycle stands on the lift table, half repaired: its rear wheel is off and stands beside it, the bike rests on a paddock stand. The radio on the bench is still playing; the coffee beside it went cold hours ago. On the wall the calendar has tomorrow circled: PICK UP 6AM. A finger-jointed shell with hazard-striped door posts holds real miniature furniture in detail ply: the motorcycle (a layered profile with tank and engine covers on both faces and a handlebar halved across the riser) on a scissor lift table, a workbenc

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs