Flight moth automaton

Flight: a moth automaton on a standing board. Turn the crank behind the board and a pin on the front disc pushes a slider up and down between two guide posts…

Settings

Units

Motion

Crank radius
Crank pin radius in mm; a bigger radius gives a bigger wingbeat
mm
Wing span
Length of each wing beyond its root, in mm; the linkage stays the same
mm

Fit

Slide clearance
Total play between the slider's slot and its two guide sleeves

Assembly

Crank angle
Crank angle in the assembled view

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Flight moth automaton

About this design

Laser cut & 3D print

Flight: a moth automaton on a standing board. Turn the crank behind the board and a pin on the front disc pushes a slider up and down between two guide posts; two links from the slider rock the wings on their fixed roots, so both wings beat together.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs