Helix Archimedes screw marble lift

Helix: an Archimedes screw marble lift. Turn the crank and a screw of 120 stacked plates, each a step round from the last on a square bar, pushes 16 mm…

Settings

Units

Screw

Flight
Plates the flight tooth spans: two leaves a longer pocket, three is stronger
Crank radius
Crank handle radius

Fit

Bar clearance
Added to the 10 mm square bar in every star-shaped hole
Bearing clearance
Added to the 20 mm journals in the end plate bearings

Assembly

Crank angle
turn lifts every marble one pitch

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Helix Archimedes screw marble lift

About this design

Laser cut & 3D print

Helix: an Archimedes screw marble lift. Turn the crank and a screw of 120 stacked plates, each a step round from the last on a square bar, pushes 16 mm marbles up a trough of dowels. At the top they drop onto a chute and roll back down a zig-zag track behind the screw to a ramp that feeds the screw again near the bottom.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs