Dabble duck automaton

Dabble: a hand-cranked duck automaton on an open cam box. Three cams on a square shaft lift three dowel pushrods through the deck: as you turn the crank the…

Settings

Units

Motion

Neck lift
How far the neck cam drops the head pushrod; more lift, a deeper dip
Wing lift
How far the wing cam lifts the wing pushrod
Tail lift
How far the tail cam lifts the tail pushrod

Fit

Clearance
Total play for the parts that turn or slide
Shaft fit
Added to the square holes for the 6 mm shaft
Dowel fit
Added to the holes the 6 mm dowel pushrods slide in

Assembly

Crank angle
wings rise and fall

Export

Output
All parts, or one group at a time

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Dabble duck automaton

About this design

Laser cut & 3D print

Dabble: a hand-cranked duck automaton on an open cam box. Three cams on a square shaft lift three dowel pushrods through the deck: as you turn the crank the duck dips its head to the engraved pond while its tail tips up, lifts its head again, then raises its wings. The pushrods are only lifted; the duck's own weight keeps them on the cams, so turn it slowly.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs