Fractal tree ornament

Fractal tree: a module that calls itself. Each branch splits in two, a little shorter and thinner, until the twigs end in leaves. The seed bends every branch…

Settings

Switch to Batch to make the same design for a list of names.

Units

Tree

Size
Diameter of the ring
Depth
How many times the branches split
Spread
Angle between two branches, in degrees
Ratio
Length of a branch compared with the one before
Wildness
How much the branches wander
Seed
Different seeds grow different trees
Leaves
Round leaves at the ends of the twigs

Text

Label
Engraved on the ground, leave empty for none

Material

Material thickness
Sheet thickness
mm
Kerf
Beam width
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Fractal tree ornament

About this design

Laser cut & 3D print

Fractal tree: a module that calls itself. Each branch splits in two, a little shorter and thinner, until the twigs end in leaves. The seed bends every branch differently, so no two trees are the same.

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs