Card Tiers

Card tiers: a stepped counter display for business cards, flyers' worth of cards for a shop or a market stall. Each tier is a pocket: a shelf, a low front lip…

Settings

Switch to Batch to make the same design for a list of names.

Units

Display

Card
Card size, width by height
Custom width
Custom card width
Custom height
Custom card height
Tiers
Number of tiers
Columns
Columns of cards on each tier
Capacity
Room for the stack of cards in each pocket
Name
Name along the bottom lip; leave empty for none

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Card Tiers

About this design

Laser cut & 3D print

Card tiers: a stepped counter display for business cards, flyers' worth of cards for a shop or a market stall. Each tier is a pocket: a shelf, a low front lip and a back that leans back 15 degrees for the cards to rest on, and each back rises to carry the next tier's lip, so the tiers climb like stairs and every card shows. Dividers split the tiers into columns for different cards. Every piece tabs into the two stepped sides, and your name is engraved along the bottom lip. Assembly: push the shelves', lips' and backs' tabs into one side, from the bottom tier up, then press the other side on. S

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs