A-Frame Sign

A-frame sign: a tabletop sandwich board for a counter, a market stall or a party. Each leaf is a plywood frame over a chalkboard panel with your words…

Settings

Switch to Batch to make the same design for a list of names.

Units

Sign

Height
Height of a leaf
Width
Width
Spread
Half the angle between the leaves
Title
Front heading
Lines
Lines under it, split with |
Back title
Back heading
Top
Top of the frames

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Clearance
Board
Chalkboard panel thickness

3D Preview

Building your model
Inspirational Palette

Code

Photos

A-Frame Sign

About this design

Laser cut & 3D print

A-frame sign: a tabletop sandwich board for a counter, a market stall or a party. Each leaf is a plywood frame over a chalkboard panel with your words engraved on the board, so they never rub off, and room below to chalk the day's specials. Tabs on top of both leaves come up through a cap that sets the spread and makes the carrying handle, and a short peg through each tab above the cap locks them, so lifting by the handle carries the whole sign. Pull the pegs and it packs flat. Assembly: glue each chalkboard panel behind its frame. Stand the leaves up, press the cap down over their tabs and pu

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs