Leonardo's Bridge

Leonardo's bridge: the self-supporting bridge Leonardo da Vinci drew around 1485, built from straight sticks with no glue, nails or rope. Each crossbar rides…

Settings

Units

Bridge

Bend
Bend at each crossbar: more bend makes a shorter, higher bridge
Segments
Crossbars from end to end, less one; even
Width
Width of the bridge

Sticks

Beam
Depth of the beams
Bar
Depth of the crossbars

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Clearance

3D Preview

Building your model
Inspirational Palette

Code

Photos

Leonardo's Bridge

About this design

Laser cut & 3D print

Leonardo's bridge: the self-supporting bridge Leonardo da Vinci drew around 1485, built from straight sticks with no glue, nails or rope. Each crossbar rides on the ends of one pair of beams and presses down on the middle of the next, so the load locks the weave tighter. The arch is not chosen: it comes from the sticks. Each bend must rise by a crossbar and a beam, and that sets the radius for the angle you pick. Shallow notches seat the beam ends on their crossbars. Assembly: lay the first crossbar on a footing against its stop, rest the outer beams on it, slide the next crossbar under their

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs