Cupcake Tree

Cupcake tree: a party stand of two tree-shaped plates slotted across each other, their branches curving up to round platforms for cupcakes. Each level's two…

Settings

Units

Stand

Levels
Levels of branches, two platforms each
Platform
Platform diameter, a cupcake's base with room
Step
Height between one level and the next
Top d
Platform for a cake on top

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Sheet
Your laser's sheet size

3D Preview

Building your model
Inspirational Palette

Code

Photos

Cupcake Tree

About this design

Laser cut & 3D print

Cupcake tree: a party stand of two tree-shaped plates slotted across each other, their branches curving up to round platforms for cupcakes. Each level's two branches belong to one plate and the next level's to the other, so the platforms climb round the trunk in a spiral, every cupcake clear of the platform above it. A branch ends in a flat pad with a tab that locates its platform; a bigger platform crowns the trunk, and the plates stand in a round base. It packs flat. Assembly: slide the plates together at the trunk, the one with the slot from the top over the one with the slot from the botto

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs