Crankie Story Box

Crankie: a moving panorama, the old storyteller's box. A long paper scroll winds from one upright spool to the other past a window, turned by the cranks on…

Settings

Switch to Batch to make the same design for a list of names.

Units

Theatre

Window width
Width of the window
Window height
Height of the window
Title
Title on the valance
Seed
Seed for the hills and pines

Scroll

Scroll length
Length of the scroll
Paper
Paper thickness
Dowel
Dowel diameter

Assembled view

Play
How far the scroll has played, 0 to 1

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm

3D Preview

Building your model
Inspirational Palette

Code

Photos

Crankie Story Box

About this design

Laser cut & 3D print

Crankie: a moving panorama, the old storyteller's box. A long paper scroll winds from one upright spool to the other past a window, turned by the cranks on top. The window's lower edge is a skyline of hills and pines, so the foreground stays still while the scene scrolls behind it, and an open back lets a lamp shine through the paper. The spools are sized from the scroll's length and thickness. Assembly: glue the box together on the plinth, leaving the top loose. Tape the scroll's ends to the dowels, wind it on, drop the dowels through the bottom holes, then fit the top and glue a crank on eac

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs