Microscope Model

Microscope: a model of an old brass-and-wood microscope that focuses. Turning either knob turns a pinion between the two walnut limb plates, which drives a…

Settings

Units

Microscope

Tube
Length of the tube
Tube r
Radius of the tube
Travel
Focus travel, up and down from the middle
Axle
Axle diameter, a wooden dowel

Assembled view

Focus
Focus: -1 is the tube all the way down, 1 all the way up
Mirror tilt
Tilt of the mirror

Material

Material thickness
The sheet you cut. Slots and tabs follow it.
mm
Kerf
Width of material the laser burns away.
mm
Spacing

3D Preview

Building your model
Inspirational Palette

Code

Photos

Microscope Model

About this design

Laser cut & 3D print

Microscope: a model of an old brass-and-wood microscope that focuses. Turning either knob turns a pinion between the two walnut limb plates, which drives a rack on the slider, and the slider carries the tube up and down. Two blocks fixed between the plates run in windows in the slider: they keep it against the pinion and stop it at each end of its travel. The tube is a strip bent round by a living hinge on two discs, with a gap at the back where the slider enters it. A stage with clips sits on the limb, and under it a mirror tilts on its tabs. Assembly: glue the slider's two layers together, a

Personal useCommercial use

How to make it

  1. 1Change the settings. The preview updates after each change.
  2. 2Download the SVG for your laser, or open it in the Design Editor to add more to it.
  3. 3Like the design and add a photo of what you made below.

Questions

Yes. It is free to download and use under its licence.

Yes. Change the settings on this page and the preview updates as you go. When it looks right, download the file.

An SVG for your laser software. You can also open it in the Design Editor, or download STL and 3MF at the material thickness to print the parts.

The size follows the settings on this page, and the size box under the preview shows the result.

Set the material thickness to the sheet you cut. The slots and tabs follow it.

Yes. The licence covers personal and commercial use of the pieces you make.

Made by the community

Cut this one? Share a photo and a note about how it went and get 10 sparks right away.

I made this

More from Kerf Designs

Similar designs